Blog

Two panels cut from the same dyed polyester fleece roll can look lighter or darker simply because the raised pile points in opposite directions. This is an optical effect of surface orientation, not necessarily a colour-dyeing mistake.

A smooth polyester lining can help a jacket, skirt or uniform slide over an inner garment. Yet too much slipperiness, static accumulation, seam drag or poor moisture handling may reduce comfort. Evaluate the lining as part of the garment system.

Polyester mesh can be woven from monofilament yarns—single continuous strands—or multifilament yarns made from bundles of fine filaments. Their surface characteristics, softness, aperture stability and cleaning behaviour differ, but performance also depends on weave and finishing.

After a polyester sublimation transfer, some visible image may remain on the paper. That alone does not establish a defective print. Poor transfer yield must be evaluated using the final fabric shade and repeatable comparisons of paper, ink, contact and press settings.

Printed polyester can develop set-off when the decorated face contacts another fabric layer before the ink or finish is sufficiently cured, dry or stable. Heat, winding pressure and long storage may make the defect appear only after the roll is opened.

Hot-knife cutting can seal loose polyester filaments at a webbing cut edge, but excessive heat may leave a stiff, glossy or brittle zone. The cut method needs to be qualified for the actual strap, not accepted on appearance alone.

Xenon-arc sources simulate a broad sunlight-like spectrum when properly filtered, while fluorescent-UV devices emphasize specified ultraviolet bands. Both can accelerate some ageing mechanisms but do not directly convert exposure hours into outdoor service life. Polyester fabric colour, tensile retention, coatings and finish deterioration require separately defined endpoints.

ISO 20743:2021 specifies quantitative methods to assess antibacterial activity of textile products, including treated, coated and integrated systems. It includes absorption, transfer and printing inoculation methods, so the chosen protocol and untreated control strongly influence interpretation. A one-time antibacterial result does not demonstrate durable performance after laundering.

Meltblown processes form fine fibres by attenuating a polymer melt with high-velocity air. In a filtration web, fibre diameter affects surface area and pore structure, but capture efficiency also depends on basis weight, web solidity, media charge, particle size, face velocity and filter assembly. Not every PET grade is suitable for meltblowing.